ENCAD T-200 Troubleshooting Guide download pdf (Page 50)

Printing 3-2

ENCAD

T-200

Reference Guide

Device and document settings

Source: Select Roll or Sheet feed media source.

Width: The width setting is unused.

Size: Select media size. Most media sizes have four similar listings for combinations of

normal or expanded margins and long or short edge feed of the media. Expanded mar-

gins provide the maximum possible image area on the media. Expanded margins are

indicated by the word "expand" in the media size. Normal margins provide a larger

border area around the image. When media size is listed with the shorter dimension first,

then the short edge of the media should be fed into the printer, and the short edge will be

the leading edge out of the printer. When media size is listed with the longer dimension

first, then the long edge of the media should be fed into the printer, and the long edge

will be the leading edge out of the printer.

Note that this media feed direction is different than the image orientation (portrait or

landscape). Set the image orientation at plot time on AutoCAD's "Plot Settings" page.

Portrait orientation puts the bottom of the image at the short edge, and landscape puts

the bottom of the image at the long edge of the media.

Max Plot Area: This reports the maximum plot area or image area that is available on

the selected paper size. The Max Plot Area depends on the paper source (roll or sheet),

margins (normal or expanded), and the media feed direction (short or long edge feed).

Destination: Choose a combination of the following items. Some may not be available

for with certain printer models.

Save Paper: When selected, the printer feeds the paper only as far as the actual plot

image rather than to declared plot size.

Cutter On: Activates the printer's cutter at the end of each plot. Media will be cut only

after the specified dry-time has elapsed.

Take Up On: Activates the printer's paper take-up device, if available.

Graphics, Vector Graphics: For this driver, the vector graphics settings apply to both

vector and raster entities.

Colors or Color Depth: Select either color or monochrome. With color, there are 255

output colors available, using AutoCAD standard 255-color palette. Under monochrome,

select either 1 shade of gray (all black) or select 255 shades of gray.

Resolution (Res.): Sets the ENCAD printer resolution. For some printer models, the

"600 dpi" choice is unavailable when the printer is set for "Colors". Some printer models

might require ink reduction at 600 dpi. Select Custom Properties to set ink reduction.

1 2 ... 45 46 47 48 49 50 51 52 53 54 55 ... 90 91

No comments

ENCAD T-200 Troubleshooting Guide Page 50