ENCAD T-200 Service Manual download pdf (Page 105)

ENCAD T-200 and T-200+ Service Manual

Assembly\Disassembly 5-3

4. Using a #2 Phillips screwdriver, loosen the top and front captive

fastener screws and remove the bottom back screw on the inside

of the Right Cover. The front captive fastener screw can be

accessed by inserting the screwdriver into the groove on the

Display Assembly as shown on the lower right side of Figure 5-1.

REMOVE SCREWS

LOOSEN CAPTIVE

FASTENER SCREWS

Figure 5-1. Removal of Right Cover Assembly.

5. Remove the Right Cover. Move the Right Cover towards the

back of the unit as you remove it so that it clears the parallel

port on the back of the unit. Be very careful when removing the

Right Cover so that the LED’s on the MPWA are not damaged.

1 2 ... 100 101 102 103 104 105 106 107 108 109 110 ... 161 162

No comments

ENCAD T-200 Service Manual Page 105