ENCAD T-200 and T-200+ Service Manual
Maintenance 3-28
Other Functional Requirements
The paper skew has a tendency to increase as the size of paper increases
(B-Size through E-Size). When adjusting the skew, make sure that:
1. the skew for B-Size paper is as close to the low end of the range
as possible; and
2. a minimum gap still remains between all Pinch Roller Supports
and the Y-Arm. The test for acceptable gap is that a piece of
bond paper can be inserted through the gap without
interference; that is, the gap must be at least the thickness of a
piece of bond paper. See Figure 3-20. Avoid adjusting the Pinch
Roller Supports so that they touch the Y-Arm’s cut outs.
THE MINIMUM ACCEPTABLE
GAP BETWEEN THESE TWO
POINTS EQUALS THE THICKNESS
OF A PIECE OF BOND PAPER.
THE MINIMUM ACCEPTABLE
GAP BETWEEN THESE TWO
POINTS EQUALS THE THICKNESS
OF A PIECE OF BOND PAPER.
Figure 3-20. Test for Minimum Acceptable Gap.
Comments to this Manuals