ENCAD T-200 Service Manual download pdf (Page 147)

ENCAD T-200 and T-200+ Service Manual

Assembly\Disassembly 5-45

5. Using your fingers, pull the Upper Pinch Roller Support forward.

Thie will seperate it from the Pinch Roller Spacer. Move the

Pinch Roller Spacer to the side.

6. Push the Upper Pinch Roller Support towards the back of the unit

and turn it 90 degrees and carefully lift it away from the Y-Arm

assembly. Guide the lower tab of the Upper Pinch Roller Support

up past the front of the Stabilizer Bracket. Make sure the Upper

Pinch Roller Support does not catch on the front edge of the

Trailing Cable and that it does not damage the Slide Shaft or the

encoder strip.

PINCH ROLLER SUPPORT

PINCH ROLLER SPACER

Figure 5-25. Removing the Upper Pinch Roller Support.

7. Working from the far left Upper Pinch Roller Support to the far

right Upper Pinch Roller Support, follow Steps 4 through 7 for

each of the remaining Upper Pinch Roller Supports. As you do so,

be sure to keep the Carriage Belt looped over the front of the Slide

Shaft so it is not damaged. ALSO, MAKE SURE YOU ARE

LOOSENING THE CORRECT SCREWS AND NOT THE

ONES WHICH HOLD ON THE STABILIZER BRACKET!

1 2 ... 142 143 144 145 146 147 148 149 150 151 152 ... 161 162

No comments

ENCAD T-200 Service Manual Page 147