ENCAD T-200 Service Manual download pdf (Page 60)

ENCAD T-200 and T-200+ Service Manual

Maintenance 3-20

For example: If the Left = 0, Right = +0.004”, then the center should

be adjusted to + 0.002”. This will ensure a smooth plane of

travel for the carriage assembly. There are no adjustments

on either end of the shaft in all models.

Head Height Alignment Procedure

Perform this procedure only when the encoder strip stabilizer has been

removed from the Y-Arm or whenever the alignment is in question.

The head height alignment procedure is to ensure that the correct

amount of distance exists between the cartridge jet plate and the Platen.

See Figure 3-13.

HEAD HEIGHT

CARTRIDGE

JET PLATE

PLATEN

Figure 3-13. Carriage Head Height Tolerance.

1. Remove the lid and the right cover of the printer. See Chapter 5

for procedures.

2. Obtain the 3 tools (Micrometer Dial Gauge, Test Cartridge, and

Measuring Tip Extender) from the Height Gauge Kit. Assemble

the tools as shown in Figure 3-14.

1 2 ... 55 56 57 58 59 60 61 62 63 64 65 ... 161 162

No comments

ENCAD T-200 Service Manual Page 60