ENCAD T-200 Service Manual download pdf (Page 141)

ENCAD T-200 and T-200+ Service Manual

Assembly\Disassembly 5-39

9. Using a #1 6” or 8” Phillips screwdriver, loosen but do not

remove the 2 black flat-head screws which hold the Stepper Motor

Assembly. Hold the Stepper Motor Assembly with your right hand

so it does not drop suddenly and use your left hand to finish

unscrewing the two screws and remove them.

10. Reach into the Fan opening on the bottom of the Platen and use

your fingertips to hold up the Fan Assembly so that it clears the

openings, screws, and cap nuts on the inside of the Platen while

simultaneously pulling the Stepper Motor Assembly and Lower

Drive Shaft Assembly out of the right end of the Platen.

Removing the Stepper Motor

NOTE

If removing only the Stepper Motor, do not remove the

Bowed Washer, Washer and Retaining Ring which are

between the end of the Lower Drive Assembly and the

Stepper Motor Bracket.

NOTE

Do not remove the 20 Teeth Gear from the Stepper Motor.

NOTE

Do not remove the Oilite Bushing from the Stepper Motor

Bracket. (If it should happen to fall out, press it back in

as far as it will go.)

NOTE

Do not clean the Oilite Bushing with alcohol. Wipe it

with a clean, dry cloth only.

1 2 ... 136 137 138 139 140 141 142 143 144 145 146 ... 161 162

No comments

ENCAD T-200 Service Manual Page 141