ENCAD T-200 Service Manual download pdf (Page 65)

ENCAD T-200 and T-200+ Service Manual

Maintenance 3-25

NOTE

The rollers should be adjusted moving from the right

side of the Platen to the left side of the Platen.

1. Load a sheet of B-Size paper and adjust Rollers #8, #7, and #6,

following the directions in the Adjustment of Pinch Roller

Supports section.

2. Load a sheet of D-Size paper and adjust Rollers #5 and #4,

following the directions in the Adjustment of Pinch Roller

Supports section.

3. Load a sheet of E-Size paper and adjust Rollers #3, #2, and #1,

following the directions in the Adjustment of Pinch Roller

Supports section.

Mounting Screw Information

1. The torque requirements for the Pinch Roller Support mounting

screws is 3 In.-Lbs. ± 0.5.

2. Turning the mounting screw clockwise will tighten the screw.

Turning the mounting screw counterclockwise will loosen the

screw.

3. Figure 3-18 shows the Pinch Roller, Pinch Roller Spacer and

the mounting screws. You must stand behind the plotter in

order to adjust the mounting screws on the Pinch Roller

Supports.

1 2 ... 60 61 62 63 64 65 66 67 68 69 70 ... 161 162

No comments

ENCAD T-200 Service Manual Page 65